The software comes pre-loaded on MCS7825H1-K9-CM50 and there is a DVD kit in the box if it needs to be re-loaded.
LIC-CM5.0-7825-H1= is the license and provides the PAK information for the licensing file. Above will definitely be required.
CM 5.0 does not check for this license SW-CCM-UL-79xx this is no longer used on CM 5.0. But LIC-CM-DL-1000= has been introduced in CM 5.0 and you will require one of the these license file LIC-CM-DL-100, LIC-CM-DL-1000, LIC-CM-DL-5000, etc.. this is a must.
Again its better that you engage your Local Partner or Cisco Accounts team
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.