I have a central CME running on a 3745 with an FXO port connected to the PSTN. I have a 1712 connected to the 3745 via VPN (I have also attemped this with a pix 501). There are 3 7970's at HQ and a 7960 at the remote location. The HQ phones can call the remote phone without issue. The phones have a shared line that the FXO plars to. When an incoming call is picked up on the remote phone, the caller can hear me, but I cannot hear the caller. Thanks for the help
Re: CME 3,3 FXO one-way audio to remote VPNed 7960
yes I did. I opened a case with Cisco and they sent me the relevant documentation. This design is supported only with a GRE tunnel. E-mail me at firstname.lastname@example.org with CME in the subject and I'll forward you the document.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...