Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CME 4.1 Phones Ringing

We are running CME 4.1 and when some users are on the phone they are getting a ringing in their ear. Is there a way to disable this or what would be a better way to set this up. Below is an example of how the phone is setup:

ephone-dn 14 dual-line

number 3051

pickup-group 123

call-forward busy 3002

call-forward noan 3002 timeout 20

ephone 8

mac-address xxxx.xxxx.xxxx

type 7941

button 1:14 2o20,11,12,13

This phone is being monitored by the receptionist using a 7914 module.

4 REPLIES
Hall of Fame Super Gold

Re: CME 4.1 Phones Ringing

Hi, that should be call waiting, user look at the display and if he likes can take the call.

If user doesn't want call-waiting,

ephone-dn xx

huntstop channel

And caller will get busy tone. This can also be done at ephone-dn-template level.

Hope this helps, please rate post if it does!

New Member

Re: CME 4.1 Phones Ringing

can you changed the call waiting tone from rining to a beep?

Hall of Fame Super Gold

Re: CME 4.1 Phones Ringing

Well, it should be a beep. I've never heard of a ringing over imposed on audio channel, what exact IOS are you running ?

Bronze

Re: CME 4.1 Phones Ringing

Hi,

I believe that you can have ringing as a Call Waiting notification but this is not default behaviour...

Try issuing the following commands.

conf t

ephone-dn x

no call-waiting ring

call-waiting beep

Hope this helps.

Regards,

Dave

135
Views
0
Helpful
4
Replies