Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

CME 4 with Unity 4.0(4)

I setup a CME(4) and want to integrate with existing Unity 4.0(4) but failed. And got the error at Unity as below:-

"Ensure that the device has been created in the CCM database and that the device name prefix is correct."

I just configure the same channel name as Unity (e.g. CiscoUM-VI1,VI2...). Is that I have missed some other configurations? Please advise if possbileb. Thanks all

2 REPLIES

Re: CME 4 with Unity 4.0(4)

If you set the Unity port name as CiscoUM-VI in Unity UTIM, then your CME config should have

ephone 1

vm-device-id CiscoUM-VI1

button 1:1

ephone 2

vm-device-id CiscoUM-VI2

button 1:2

New Member

Re: CME 4 with Unity 4.0(4)

Thanks for your reply.

I have done it but not successful.

Part of the config is as below:-

--------------------

ephone-dn 4

number 111

name VOICEMAIL1

no huntstop

ephone-dn 5

number 111

name VOICEMAIL2

no huntstop

ephone 4

vm-device-id CiscoUM-VI1

button 1:4

ephone 5

vm-device-id CiscoUM-VI2

button 1:5

----------------------

However, when I debug the ephone register, I got this messages.

----------------------

New skinny socket accepted [1] (1 active)

sin_family 2, sin_port 2404, in addr 10.10.10.1

skinny_add_socket 1 10.10.10.1 2404

----------------------

Thanks for advices

101
Views
1
Helpful
2
Replies