I recently upgraded to CME 7.1 to enable the SNR function. Configured everyting according to documentation and thought everything was working fine. While I was testing I only tested from internal phones and this worked.
IP Phone A has SNR DN of Cell Phone Z
IP Phone B calls phone A
IP Phone A rings and Cell Phone Z rings
I can pick up either IP Phone A or Cell Phone Z and all mobility functions work correctly
Does not work
Cell Phone Y calls IP Phone A
IP Phone A rings but Cell Phone Z DOES NOT RING
I did a debug voice ccsip to see if there was anything funny going on with the outgoing call, but didn't see CME even attempt to send an invite out
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.