With CME 4.0 there is a new speed dial called bulk speed dial. You store the speed dial list in a text file in flash. The file will have a list number say 2, you can set the speed dial prefix to be # (which is default). Then each speed dial entry may have a entry number say 00, 01, 02, 03 etc.
To dial entry number 00, you dial #200 where # is the prefix, 2 is the list number and 00 is the actual entry. You can have up to 10 such lists and the 10 files together can hold up to 10000 entries.
The first entry is for entry number and second for the actual speed dial entry and the third the speed dial display name. When you dial #200, you see Test1 on the phone, so you know which speed dial you are dialing.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...