Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CME Caller ID

We are connected to the PSTN through a T1 with E&M Wink Start. We currently only receive the 10 digit called number.

When we asked about receiving caller ID info, our provider asked how we would like them to present CLID and DNIS to us. We're not sure how to answer this question. What information should we give the provider so they can get the information to us correctly, and is there any extra configuration in CME(4.0) we'll need to do to receive this?

Thanks,

Andy

2 REPLIES
New Member

Re: CME Caller ID

Hey, everyone. This is my last check to see if anyone can help me with my question above. If anyone has any information or can point me in the right direction, it would be much appreciated.

Thanks,

Andy

Blue

Re: CME Caller ID

i would tell the provider to send 'all digits and CLID information'.

your voice gateway can then either pass it on to the system/you, or discard it.

(depending on your configuration)

if you are able to get all the data from the provider but not sure how to use it in your gateway or system, let us know what you're being provided and we can help further.

is this an mgcp gateway or h323? is this an ISDN PRI where you can use the Qsig IE information? (are you sure it's e&m)

depending on the gateway configuration and protocol(s) used, there may be a few ways to use the data.

for CME, you'll need a 'forward-digits' statement under your dialPeers for the specific digits you want to forward. you can also use 'callerID enable' under the voice port to name a couple of settings possible.

there are a few more options you can do with CLID/DNIS info.

for more info on CLID commands with IOS, see the following link:

http://www.cisco.com/en/US/products/sw/iosswrel/ps5207/products_command_reference_chapter09186a008041ef72.html

for more info on DNIS commands with IOS, see the following link:

http://www.cisco.com/en/US/products/sw/iosswrel/ps5207/products_command_reference_chapter09186a00801a7f24.html

268
Views
0
Helpful
2
Replies
CreatePlease login to create content