Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

CME - Default DID "Catch All"

Hi all,

I'm sure this is a basic question, but not one I've thought about before. The scenario is as follows:

I have a CME with 10 extensions. I also have an ISDN line with 50 DDI's on it. Each extension has its own DDI, but there is also another 40 DDI's that are currently unallocated. Is there anyway to send these 40 DDI's to a specific DN (i.e. a huntgroup) so that if somebody misdials a number, the call will still get routed?

1 REPLY

Re: CME - Default DID "Catch All"

You could set translation rules on incoming called-numbers to translate a range of DIDs to one number.

voice translation-rule 1

rule 1 2840 2000

rule 2 2841 2000

...

voice translation-profile Incoming

translate called 1

dial-peer voice 1 pots

port 1/0:23

translation-profile incoming Incoming

HTH

179
Views
0
Helpful
1
Replies
CreatePlease to create content