Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

CME/SRST to test PRI and calls for new turnup in and out.

Can someone give me a simple CME config to test a new PRI at a site with one phone? The WAN that will connect to our call manager will be going in after the voice circuit and I'd at least like to test calls inbound and outbound if possible with CME. The router will be a Cisco 2851 running IOS 12.4.4(XC2) Advanced IP services. In production the router will be the SRST gateway.

Not sure if you can test it with SRST if it never talked to CM before...

Thanks.

  • Other Collaboration Voice and Video Subjects
1 REPLY

Re: CME/SRST to test PRI and calls for new turnup in and out.

You cannot test it with SRST as the phone needs to talk to CM once. So you can use CME.

here is a sample config.

isdn switch-type primary-ni <--replace with yours

controller t1 0/0/0

pri-group timeslots 1-24

framing esf

linecode b8zs

clock source line primary

telephony-service

ip source-address 192.168.10.1 port 2000

max-dn 2

max-ephones 1

create cnf-files

load 7960-7940

tftp-server flash:

ephone-dn 1 dual-line

number 2000

ephone 1

mac-address

button 1:1

int s0/0/0:23

isdn incoming-voice voice

isdn switch-type primary-ni

dial-peer voice 1 pots

destination-pattern 9T

port 0/0/0:23

incoming called-number .

Notes: You may have to give a card type command if its a vwic2-mft card which may be t1 or e1 or using a nm-hdv2. Also you will need to extract cme 4.0 basic files (downloadable from CCO) and atleast put the 7960/7940 phone load (or the load for which ever phone you are using) so that the phone will be able to boot up and register with CME.

HTH

Sankar

PS: please remember to rate posts!

404
Views
0
Helpful
1
Replies