Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

CME to Broadsoft SIP trunkgroup outbound calls

This is my dial-peer for outbound calls over SIP trunk. Does not work. Number not found - any ideas?

dial-peer voice 1 voip

translation-profile outgoing PSTN_Outgoing

huntstop

destination-pattern .T

voice-class codec 1

session protocol sipv2

session target sip-server

dtmf-relay rtp-nte

ip qos dscp cs5 media

ip qos dscp cs4 signaling

no vad

2 REPLIES
Anonymous
N/A

Re: CME to Broadsoft SIP trunkgroup outbound calls

What is the error message you are getting?

Community Member

Re: CME to Broadsoft SIP trunkgroup outbound calls

your SIP provider may only provide G711ulaw audio, as mine does. If so, the above configuration will not work by itself, as voip dial-peers use g729r8, by default. add the following command under the dial-peer:

codec g711ulaw

199
Views
0
Helpful
2
Replies
CreatePlease to create content