I have CME and CM connected to GK.
When I configure a dial-peer with session target ras with more than 4 digits it doesnt even hit the GK all other calls with 4 digits or less work.
This is OK for extension as the dial-plan is 4 digits on CM. But we want to use least cost routing.
We have tested setting up dial-peer with 1111 and sending to CM via the GK then doing a translation pattern on CM example 1111 = translated called number 01161199XXXXXX and this works fine the call goes out PSTN.
This call signalling flow is CME--GK--CM__TransPattern-PSTN_GW (success to PSTN)
Would like to be able to setup a RAS dial-peer on CME with more than 4 digits but it just fails. By the way the GK trunk on CM significant digits field is set to ALL.
Also testded a voip dial-peer with session target ip address of CM and this works fine no problems any number hits CM and gets routed out PSTN.
GK RAS peer example
Dial-peer voice 44 voip
destination-pattern 1923 (any combo of 4 digits or less works)
session target ras
dtmf-relay ....
Any suggestions
Thanks
Allan