Testing the CME transcoder functionality to access CUE via CME from CCM IP phone but it doesn't work with NM-HDV even works okay with matherboard PVDM2. CME router IOS12.4(3e), CME 3.3 and CUE2.1.2
The call from CCM IP phone successfully forwared to CUE based on the debug on CUE but silent on the phone. only one session in " show sccp connection" and randomly change the codec to g729 and g711. sometimes display both codec(two session) but silent also that this moment. please advise to resolve the issue.
dsp services dspfarm
voice service voip
allow-connections h323 to h323
allow-connections h323 to sip
allow-connections sip to h323
allow-connections sip to sip
sccp local FastEthernet0/0.102
sccp ccm 10.253.66.254 priority 1
dspfarm transcoder maximum sessions 4
sdspfarm units 2
sdspfarm transcode sessions 6
sdspfarm tag 1 mtp000dbc9d9e80
CME#sh sccp connections
sess_id conn_id stype mode codec ripaddr rport sport
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...