Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CME translation-rule help

I am running cme 3.1. I am trying to translate a dialed number of 0 into 1001. 1001 is the extension of the operator. My translation rule is as follows:

translation-rule 1

Rule 0 0 1001

When i run a test translation-rule 1 0 i get the following output:

test translation-rule 1 0

The replaced number: 1001

So it looks like it should be working.

Can anyone shead some light on this for me?

Thanks

Frank

1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Re: CME translation-rule help

Yes the translation rule is correct. You need to make sure that you apply it to the correct voice-port or ephone-dn.

ephone-dn 1

number 1005

translate called 1

1 REPLY
Silver

Re: CME translation-rule help

Yes the translation rule is correct. You need to make sure that you apply it to the correct voice-port or ephone-dn.

ephone-dn 1

number 1005

translate called 1

225
Views
0
Helpful
1
Replies