11-13-2005 05:24 PM - edited 03-13-2019 11:13 AM
I have a CME Unity SIP Integration problem. I can access Unity via Message Button. I can get message via UM.. But when trying to access the mailbox via Telephone it wont relay DTMF's...
Config
dial-peer voice 150 voip
destination-pattern 55550..
session protocol sipv2
session target ipv4:192.168.X.X
dtmf-relay rtp-nte
codec g711ulaw
Am I missing something??
Thanks
JC
11-14-2005 01:49 PM
If this is CUE sip integration, then I think you want to use dtmf-relay sip-notify, and no vad.
Mary Beth
11-14-2005 08:46 PM
Well further investigation; I've reverted back to SCCP but now the CME to UM integration has turned up odd behaviors. While watching the Call Viewer I see the Unity is receiving my extension inversed.. ie: ext: 1234 is getting seen by unity as 4321.. which of course causes some slight issues...
Any thoughts?
11-15-2005 06:00 AM
The following configuration guide should be a big help: http://www.cisco.com/en/US/products/sw/voicesw/ps2237/prod_configuration_guide09186a00801c4185.html
As for the DTMF relay according to the link above you should use the: dtmf-relay h245-alphanumeric
Hope this helps.
Steve
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide