CME w 12.4(4) IOS 1760 caller id FXO

[shaun.white]

When i go in under my voice-port 1/0 there is no caller-id enable command? Is this not the command? I want to enable caller id on my FXO trunk

Thanks in advance

[thisisshanky]

Try the command with out the no.

[shaun.white]

sorry i wasnt clear there...what i meant was there wasnt any caller-id command under global config or under the voice-port config for my FXO card...any other ideas?

TIA

[rhugo]

Try rolling back to an earlier train. I would suggest 12.3(11)T10. Also make sure your Feature Set is at least IP Plus. Here is the IOS command reference:

http://www.cisco.com/univercd/cc/td/doc/product/software/ios123/123tcr/123tvr/vrht_c4.htm#wp1058921

Also, make sure you are using a VIC-2FXO-M card or greater if you want to use caller-id. Here is a reference link

http://www.cisco.com/univercd/cc/td/doc/product/software/ios123/123tcr/123tvr/vrht_c4.htm#wp1058921