Have you set the CME router as NTP server from the CUE box ? Are you able to ping the CME ip address from CUE ? Make sure you have a static route in CME for CUE's ip address, pointing to the serviceengine interface.
Like Sankara mentioned, you'll need to setup your CME router as a ntp master. Then you will need to access you cue module.. service-module service-engine 0/x session. Once logged in you will need to go to config mode and type ntp server "ip address of router". Make sure you can pig that address from the CUE module.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...