Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CMM DSP's registered to multiple clusters?

Can I have T1 ports or transcode resources on a single CMM register to separate call manager clusters? For example 3 T1's and half the xcoder's register to Call Manager "A", and the other 3 T1's and the remaining xcoders register to Call Manager "B".

Thanks.

1 ACCEPTED SOLUTION

Accepted Solutions
Green

Re: CMM DSP's registered to multiple clusters?

Yes, you can.

You need to configure multiple sccp ccm groups and there you associate the profiles.

It is for C5510 but it applies for CMM -ACT

http://www.cisco.com/univercd/cc/td/doc/product/software/ios123/123cgcr/vvfax_c/callc_c/ccm_c/intcnf2.htm#wp1027848

1 REPLY
Green

Re: CMM DSP's registered to multiple clusters?

Yes, you can.

You need to configure multiple sccp ccm groups and there you associate the profiles.

It is for C5510 but it applies for CMM -ACT

http://www.cisco.com/univercd/cc/td/doc/product/software/ios123/123cgcr/vvfax_c/callc_c/ccm_c/intcnf2.htm#wp1027848

142
Views
0
Helpful
1
Replies
CreatePlease login to create content