Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

CMM Module

I have a CMM modoule running 12.x.x. I can ping the GIGabit Ethernet IP address but I am getting ping packet loss when I ping the fast Ethernet IP address in the CMM module.

Is the fast E on the CMM supposed to b e pingable cause it has a /32 subnet mask (accdg to Cisco).

I dont have issues pinging the Gigabit Ethernet.

I have 1 6port T1 and 1 Conf Module on the CMM. Conferencing works fine.

Just trying to figure out if pinging fast E is supposed to work...

Thanks,

3 REPLIES
Green

Re: CMM Module

It should be pingeable since RTP stream is mix there and audio actually is sourced from that interface.

Make sure FE is configured in the proper VLAN.

Bronze

Re: CMM Module

Paul

On my CMM I can ping both.

My configuration is similiar to yours, 1 6-port T1 module and 1 Conference Module.

Larry

New Member

Re: CMM Module

Thanks. My ping works but not all the time. I tried to reload using the hw-module command and seem to fix it for now...I'll keep you posted...

119
Views
0
Helpful
3
Replies