10-23-2006 10:22 AM - edited 03-13-2019 03:30 PM
I have a CMM modoule running 12.x.x. I can ping the GIGabit Ethernet IP address but I am getting ping packet loss when I ping the fast Ethernet IP address in the CMM module.
Is the fast E on the CMM supposed to b e pingable cause it has a /32 subnet mask (accdg to Cisco).
I dont have issues pinging the Gigabit Ethernet.
I have 1 6port T1 and 1 Conf Module on the CMM. Conferencing works fine.
Just trying to figure out if pinging fast E is supposed to work...
Thanks,
10-23-2006 10:36 AM
It should be pingeable since RTP stream is mix there and audio actually is sourced from that interface.
Make sure FE is configured in the proper VLAN.
10-23-2006 12:59 PM
Paul
On my CMM I can ping both.
My configuration is similiar to yours, 1 6-port T1 module and 1 Conference Module.
Larry
10-24-2006 05:12 AM
Thanks. My ping works but not all the time. I tried to reload using the hw-module command and seem to fix it for now...I'll keep you posted...
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide