I have two DHCP servers, CNR (release 6.2)& Windows DHCP server.
Using the windows DHCP server (via a helper command) I can plug any model phone into the same port and they will be assigned an address from the correct scope.
Changing the helper command to use the CNR server results in the same behavior except that 7970 phones will not accept the address offered by the CNR server. All other phones & laptops work ok. Tried 3 different 7970s, upgraded firmware, ensured previous address was released, factory reset etc . All requested fields are offered to the client.
Only error i can find is in the 'console logs'....
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...
If you have 2 ISR routers, one acting as Failover, do we need to have both the same number of SRST licenses on the 2 routers?
No. You will only need the SRST licenses on the primary router. Because this feature...
You have reached the Cisco Logistics Support Center.. To Check Status of your RMA, visit Product Returns & Replacements (RMA).
Need help? Contact us by Phone or Email.
Phone: 1800 553 2447 Option 4