I have a Dial-Peer on a ios gateway, when i change the bytes per packet i.e. "Codec g711ulaw bytes 240" I can make one call, and afterwords the port sticks in an off hook state (FXS Port) and I get DSP timeouts basically. I have tried this on a 2651XM and a 3745. Running 3 different versions of code. I changed the service parameter in CallManager for G711 to 30 and same thing. I have to reboot the router to recover the port, but again after a single call, same thing. Any ideas?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...