Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

CODEC Uses

Why if i setup de voice peers to use CODEC 723r53, when type "sh call history voice" show

CoderTypeRate=g729r8 pre-ietf

???

2 REPLIES
New Member

Re: CODEC Uses

Cisco Employee

Re: CODEC Uses

Have you verified it is the same on both ends? You also need to verify that dial-peer is used in the call. If it is configured on both ends add "incoming called number ." on the VOIP dial-peer. This will force the router to use that peer for negotiation. If that doesnt work yo may want to open a case and have an Engineer look at it further.

116
Views
0
Helpful
2
Replies