Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Codecs question

Hi,

I know that G.729 is suitable in WAN links for BW savings, but what if I'm using the G.711 on a high bandwidth WAN link, and I need a method when for example when (X) concurrent calls happen the next call should change its codec based on sender and receiver ip phones to G.729, is there such method on CCM or GW/GK to achieve this?

thanks

4 REPLIES

Re: Codecs question

if you use a gatekeeper to route between two clusters, you can do this using multiple route groups and trunks (one set to g711 and other set to g729). If the phones are all on the same cluster, then you can limit the calls by location bandwidth. and the type of codec (bandwidth per call) will be determined by the region setting. When the location bandwidth limit is reached, you can trigger AAR to dial over pstn.

HTH

Sankar

PS: please remember to rate posts!

New Member

Re: Codecs question

p.s correct me if I'm wrong, as I understood from ur answer that over IP WAN (VoIP calls) with the same cluster it is not possible to change from one codec automatically to another if limit is exceeded, I just have the option to reroute to pstn via AAR

is this right?

Re: Codecs question

Thats correct.

New Member

Re: Codecs question

many thanks for,

your answers indeed are extremely helpful

116
Views
5
Helpful
4
Replies