I looking for a possibility to localize the ip communicator at a CME 4.1.
There are locales for every other phone on the cisco page, but no for an communicator. the debug shows that the communicator is looking for cipc.sccp.jar.
Is it possible to make an cipc.sccp.jar alias name for example the td.sccp.jar, so that communicator except this file as it localization file, because the communicator is only a software version of an 7970?
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.