I have loaded Unity onto a Compaq DL380 which is the same as a Cisco MCS 7835. Here is what I had to do:
Start the build with the Compaq SmartStart (blue) CD and setup your arrays and create your EISA partition. Load Windows NT/2000 when asked. Another note, if you load Windows 2000 and make it a member server of a domain, you may get an error message when you attempt to install Exchange 5.5 that states: "The server must be a member of a domain before you can install Exchange" Edit this registry entry: HKLM/Software/Microsoft/WindowsNT/CurrentVersion/Winlogon Change the "DefaultDomainName" to the domain instead of the Server name.
Matt Slaga TimeBridge Technologies MCNE, MCSE2k-4.0-3.51, CCNA, CIPT2.0
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...