As long as the array controller is the same, you shouldn't have a problem. The array controller information and array (RAID 0) set is stored on the SCSI disks. If the array controller is the same on the MCS 7835 (newer models use the 5si) then you should be able to move the drives.
If you have a mirror set on the compaq now... take out Disk 1 and place it in the MCS. If it boots and runs then you are in the clear.
Of course always back up your data. If the array controllers are not the same then you will need to back up the Cm server which creates an .sti file in the directory or tape location you specify.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...