Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Conference Problems CM 3.3(3)

When an outside call is conferenced to a 2nd internal station (7960 phone), if either station hangs up the call is completely dropped. The gateway is a 2620 with fxo/fxs and the same thing happens with either outgoing or incoming calls. Can anyone offer advice?

Thanks!!

6 REPLIES
New Member

Re: Conference Problems CM 3.3(3)

Under Service Parameters, check the field "Drop Adhoc Conference When Creator Leaves". Make sure it's set to False (default).

New Member

Re: Conference Problems CM 3.3(3)

Do you have the conference bridges in media resource groups? If not put them in one. You may also have to put your MTP and MOH in the group too.

Hope this helps.

Thanks

Frank

New Member

Re: Conference Problems CM 3.3(3)

Clarification point. This is a software conference bridge. It doesn't matter which phone hangs up, the original conferencer or the conferencee, both are disconnected.

New Member

Re: Conference Problems CM 3.3(3)

I understand the fact that they are software cfb. Are they in a media resource group?

New Member

Re: Conference Problems CM 3.3(3)

Yes, the cfb is in a media resourse group now. Originally it was not, but I added that today, with the same results.

New Member

Re: Conference Problems CM 3.3(3)

Make, sure that you also assign that media resource group to a media resource list, then assign that media resource list to the device pool that all the phones are using(Be sure to reset the phones after making this change).

95
Views
0
Helpful
6
Replies