You will need to setup an MCU (multi-point conrol unit), so that it can create the video conference. The functionality is not built directly into Unified Communications Manager, but requires separate hardware.
We have some Tandberg video endpoints that contain a 4 (maybe 5) device internal MCU, so we utilize that device to conference in multiple video devices, but the Tandberg has to do all of the calling to achieve that, so they can't be built dynamically like a conference call is.
We have a Tandberg 550MXP with integrated MCU that we would like to use with a CCM6.0 to place videoconference among more than 2 parties. Please, could you explain to me how to configure the MCU in the CCM to get it working?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...