Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Config. CM 3.1 send nothing to the network

With mask configured, call manager will send mask to network, which is user side marked or labeled--untrusted since user can mask with any numbers, without mask, CM will send Individual lines (expose individual num.). Does CM 3.1 support send nothing? so Telco (network marked-trusted) will apply the default mask for the PRI trunk?

Jun

4 REPLIES
Cisco Employee

Re: Config. CM 3.1 send nothing to the network

On the PRI configuration in CCMAdmin for the 6608 port, you should be able to change the "Presentation Bit" to Restricted and whatever number you send out will not get displayed.

Or, on the route pattern (or the gateway config) you can specify what the outbound caller ID should be for any call to that pattern or through that gateway and you can set it to the main number.

New Member

Re: Config. CM 3.1 send nothing to the network

currently using mask on gateway-user side. tried "presentation Bit", called phone received no DN, telco default mask failed to apply.

Cisco Employee

Re: Config. CM 3.1 send nothing to the network

So you are saying that the called phone on the PSTN side is getting no caller ID at all?

Another thing you can try is on the gateway config, change the Calling Party Numbering Type Unknown set to Unknown, and the Calling Party Plan to Unknown.

If that combination does not work, try calling party type national and calling party plan isdn.

If neither of those works then we may need to see a trace, try a couple other configs, and make test calls.

New Member

Re: Config. CM 3.1 send nothing to the network

Thanks. Had tried these, not working, had passed this to telecom manager to ref. and to telco.

114
Views
0
Helpful
4
Replies
CreatePlease login to create content