Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Config req'd Ericsson MD110 on 2600 router

I have 2 sites with MD110 PBX LIMs.

They use Ericsson proprietry inter LIM signalling.

I have a 2600 router with 1 E1 interface and 1 WIC1T

interface at each site with a 2M link between sites.

Any suggestions for a router configuration would help.

1 REPLY
New Member

Re: Config req'd Ericsson MD110 on 2600 router

We have a similar setup. We use dial-peer to push the call out via the BRI card.

If you need to know how to configure the E1 card on the MD110 Ericsson should be able to do this. They configured ours to do it.

131
Views
0
Helpful
1
Replies
CreatePlease login to create content