Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
You may experience some slow load times, errors, and slight inconsistencies. We ask for your patience as we finalize the launch. Thank you.

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

configuration- 2MFT-E1-DI

Hi People

Please help me how to configure 2MFT-E1-DI for voice only ISDN PRI with 2600 router.

Do I need to obtain any IP from telco..please guide me what things I need to obtain form telco and configure.

Thanks people

  • Other Collaboration Voice and Video Subjects
2 REPLIES
New Member

Re: configuration- 2MFT-E1-DI

Hi,

U need not require the IP from the service provider for E1(VOICE).

U only need to know the framing standard that is provided SP,linecode,clock source and lastly but the most imp the isdn-switch type.

Make sure u know how many channels to bring up and u have the sufficient DSP resources

Hope this helps

Abhishek

New Member

Re: configuration- 2MFT-E1-DI

Hi Abhishek,

Fowllowing is the router configuration I made and respective show commands.

For loopback testing purpose I assigned Ip addressed to D channel as 10.46.10.1.The result that also appended at end of attachement.

DSP wise its OK.

It seems my configuration is right somewhere went wrong.what to do further.

thanks

104
Views
0
Helpful
2
Replies