Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Configuration of VIC2-2BRI-NT/TE

Can you help me how to configure my ISDN card.

I have version 3.2 of CME and a 2801 router.

Internally call are working OK.

Victor

  • Other Collaboration Voice and Video Subjects
5 REPLIES
Silver

Re: Configuration of VIC2-2BRI-NT/TE

Check out this link for setting up ISDN

http://www.cisco.com/en/US/tech/tk652/tk653/technologies_configuration_example09186a008010ef6c.shtml

Once you have ISDN working, you need to setup dial-peers for incoming and outgoing calls. Check this link for dial-peers

http://www.cisco.com/en/US/tech/tk652/tk90/technologies_tech_note09186a008010fed1.shtml

Regards,

Anup

New Member

Re: Configuration of VIC2-2BRI-NT/TE

Thanks. I used your link but it is not working.

There is someting strange. some times the light near the cable is on, sometimes it is off. What is the correct situation?

I am sendig the attachment of my running configuration.

Silver

Re: Configuration of VIC2-2BRI-NT/TE

The light going off and on sounds like a cabling issue or a bad card. Check the cables and also check with your ISDN service provider to verify connectivity.

Is the switch type supposed to be basic-net3? Please verify with your service provider.

When you do a "show isdn status", what is the Layer 1 and Layer 2 status?

Regards,

Anup

Re: Configuration of VIC2-2BRI-NT/TE

Hello,

You should see multiple frame established if your talking to the isdn provider when you issue the "show isdn status" command.

Patrick

New Member

Re: Configuration of VIC2-2BRI-NT/TE

The is the message with sh isdn status:

RGrafer#sh isdn status

Global ISDN Switchtype = basic-net3

ISDN BRI0/0/0 interface

******* Network side configuration *******

dsl 0, interface ISDN Switchtype = basic-net3

Layer 1 Status:

DEACTIVATED

Layer 2 Status:

Layer 2 NOT Activated

Layer 3 Status:

0 Active Layer 3 Call(s)

Active dsl 0 CCBs = 0

The Free Channel Mask: 0x80000003

ISDN BRI0/0/1 interface

dsl 1, interface ISDN Switchtype = basic-net3

Layer 1 Status:

ACTIVE

Layer 2 Status:

Layer 2 NOT Activated

Layer 3 Status:

0 Active Layer 3 Call(s)

Active dsl 1 CCBs = 0

The Free Channel Mask: 0x80000003

Total Allocated ISDN CCBs = 0

RGrafer#

Note that I have only coneted one cable (Isdn line) to port 0/0/1.

Is the reply OK to you? Layer 2 is Not Activeted? Why?

I only can contact my service provider on Monday.

Regards,

Victor

:-)

228
Views
0
Helpful
5
Replies
This widget could not be displayed.