Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Configuring a NM-HDV-2E1 for E1 R2

Hi,

I've to configure a NM-HDV-2E1 with E1 R2 signalling on a cisco 3640 router.

Before, I've already configured a Patton Access server, and all have worked properly. I want to reproduce the same config on the cisco but I couldn't find the correcponding parameters.

Here the working parameters on the Patton access server :

Line Signalling :

----------------------

Country: custom(2)

Idle Code: abcd-1001(9)

Forward Seize: abcd-0001(1)

Back Acknowledge: abcd-1101(13)

Back Answer: abcd-0101(5)

Minimum Transition Time (ms): 400

Minimum Detection Time (ms): 0

Protocol Timeout (ms): 130000

Can anyone tell me what's the corresponding config on the cisco router, because i've searched on the online docs for this detailed config and I've not found anything about.

Thanks in advance.

Fethi.

P.S. My country is Algeria, if it helps !

1 REPLY
Silver

Re: Configuring a NM-HDV-2E1 for E1 R2

Hi Fethi,

I don't know if Algeria has a custom version of R2, but if they use ITU defaults the following should work -

controller e1 0/0

ds0-group 0 timeslots 1-31 type r2-digital r2-compelled

voice-port 0/0:0

cptone FR

compand-type a-law

dial-peer voice 1 pots

incoming called-number .

direct-inward-dial

port 0/0:0

Have a look here for more information on configuring and customising R2 -

http://www.cisco.com/warp/public/788/signalling/e1_r2_sig.html

http://www.cisco.com/warp/public/788/signalling/e1r2config.html

http://www.cisco.com/warp/public/788/signalling/e1_r2_cas_custom.html

228
Views
0
Helpful
1
Replies