Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Configuring a SIP to SIP Gateway

I am trying to configure a SIP to SIP gateway so I can get a SIP trunk through the firewall. Do I use Dial Peers to direct the traffic? The document gives me basics but not specifics.

3 REPLIES
Hall of Fame Super Gold

Re: Configuring a SIP to SIP Gateway

Yes you use dial-peers voip for both inbound and outbound. Generally speaking, you will have "codec transparent" set on these.

You will need and IP-to-IP image to do that, filename ends in _isv, but you probably knew that already.

Does it helps? please rate post if it does!

New Member

Re: Configuring a SIP to SIP Gateway

No, I didn't know this. I am using a 2821 router running this image: c2800nm-advipservicesk9-mz.124-11.T1.bin. Will this work?

Hall of Fame Super Gold

Re: Configuring a SIP to SIP Gateway

No I don't think it will work. Anyway, another needed piece of configuration is:

voice service voip

allow-connections sip to sip

Then, to see how things are going, "term mon" and "debug ccsip message" when placing a call.

Thank you for the nice rating and good luck!

217
Views
10
Helpful
3
Replies