We need to make an external ringer w/ our IP phone system. We have purchased the ATA 186 for this function. We have the 6509 rack w/ 2-48 port cards, a T1/E1 PRI Card (2 PRI's in use) and a 24port FXs card. The T1/E1 card is setup as a gateway (digigal access pri for device protocol). What IP config's on the ATA box do I need to set up for it to be recognized on the network? I set the Gateway IP address to the T1/E1 Card, but it doesn't seem to be defined for H.323. I don't know what IPs to assign for the Gatekeeper, Gateway, Router etc. Do I need to add another gateway and/or Gatekeeper to the 6509?
I have set that much up. I gave it an IP address on the same subnet as my IP Phone (same router as well). I still can't communicate w/ it though. How do I need to set up the Call Manager for it to recognize the device and give it a phone number?
Did you ever get the external ringer working? We have 2 ringers that are currently on an ATA186 and are not working. I can get dial tone from the ATA device as well as the house pair on the Bix connection but when I call the ringer number it does not ring the bell externally and it hangs the phone that the bell is attached to for about 2 minutes where the phone is out of service. Any ideas as to why this is not working???
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.