Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

configuring CME

I'm configuring the CME in setup automatic mode and I have some questions.

When you assign Ip address to the TFTP server normally in in the same range than the DHCP server?

Could be the same IP address inside the Router?

for example 10.0.0.1 both?

regards

1 REPLY
Hall of Fame Super Silver

Re: configuring CME

If I am reading your question correctly you are asking which IP to use as for the TFTP service on the router?

If that is what you are asking for, the TFTP IP is the one assigned under telephony-service configuration as ip source-address and it can be any IP of any of the router's interface.

Chris

113
Views
0
Helpful
1
Replies
CreatePlease to create content