Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 

Configuring Controller E1

Hi,I want to connect my router with my PABX using a controller E1. The card I have in the PABX is a TLU76/1. I need to know how to configure my router? I'm using CCME.

I appreciate your help

regars

Leo

2 REPLIES
Silver

Re: Configuring Controller E1

Hi,

I don't think there is a difference in configuring an E1 Controller on CME to an ordinary voice router. Here is a standard E1 config:

isdn switch-type - "specify what type you are using"

!

controller E1 2/0

framing - "specify framing type (crc4 etc)"

pri-group timeslots - " specify timeslots"

!

!interface Serial2/0:15

isdn switch-type - "specify type again"

!

voice-port 2/0:15 -

New Member

Re: Configuring Controller E1

Hi

Please check this document describing interoperability between the Ericsson MD110 PABX and a Cisco router.

http://www.cisco.com/application/pdf/en/us/guest/products/ps278/c1237/ccmigration_09186a00800e6e6c.pdf

Additional guides for Ericsson PABXs can be found here:

http://www.cisco.com/en/US/products/hw/routers/ps259/prod_troubleshooting_guide09186a0080142535.html

Regards.

188
Views
0
Helpful
2
Replies
CreatePlease to create content