How to configure DID SIP trunk to SIP server on CUCM v9.1?
i have CUCM server 9.1, and i need to configure SIP Trunk server (STC server ), i did the routing and i can ping it but i don't know how to implement it incase of i configured my voice gateway H323 or SCCPand which one is the best ????
thank you brother i tried the SIP Trunk and alhamd lelah finally its working after more troupleshooting, BUT still have avery big problem : i have 2 models of cisco phones deployed in this network: -1-) 6941 sccp phones and its working well incoming and outgoing calls
-2-) 9951 sip phones that are working good for incoming calls but for outgoing calls make disconnect problem after reply
i mean : only from 9951 phones when i call any outside company number(national or international or mobile) it disconnect the call directly after the destination reply to the call
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...