Configuring E1 voice circuit in Mexico. Using MGCP
Just installed 3845 with E1 voice circuit (VWIC2-1MFT-T1/E1) in Mexico. Using a single cluster centralized design. We have got a problem to pass calls to and from my telephone service provider. The e1 is registered in CCM as a voice gateway using MGCP.
We were told the E1 voice circuit detail as below.
Framing is NO-CRC4, Line Code is HDB3, Clock Source is Line
If someone has been successfully configured E1 with MGCP Mexico, appreciate can show us a list of parameters for this type of gateway setup (3845 with VWIC2-1MFT-T1/E1 running MGCP) in CCM.
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...
If you have 2 ISR routers, one acting as Failover, do we need to have both the same number of SRST licenses on the 2 routers?
No. You will only need the SRST licenses on the primary router. Because this feature...