configuring llq with rtp priority on 7500 and vip2-40
I wonder to know if someone already configured on a 7500 with vip2-40 board frame relay links to pass voip and data, the data needs to have priorization levels like high, medium. I tried to use ip rtp priority and fragmentation on a map-class, and for data a llq but the vip board started to have crashes. Does someone knows a stable configuration?
Re: configuring llq with rtp priority on 7500 and vip2-40
Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen
If anyone else in the forum has some advice, please reply to this thread.
IntroductionCUCM Routing RulesDial String implementation PolicyCUCM Routing LogicSIP URI Call Routing Analysis+++ Case Study: 1 ++++++ Case Study: 2 +++Conclusion
Over the last few months, I have had the privilege of working on SI...
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...