Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

configuring MGCP BRI endpoints

How does one get the CM to give an option to configure a VIC2-BRINT4/TE card for an MGCP gateway? This is CM 4.1.3 and originally it didn't have an option for it. After installing sr3a, it now has the NM-4VWIC-MBRD but the only option under that is VIC2-2BRI. The endpoints won't register with that. Is there another Service Release, dev pack or ES that can add more options to the MGCP configuration? The gateway is a 2811 and the code is 12.3.11T5. Thanks.

1 REPLY
Silver

Re: configuring MGCP BRI endpoints

For information regarding configuring MGCp bri end points refer the link ,

http://www.cisco.com/en/US/products/ps6441/products_configuration_guide_chapter09186a0080541c9f.html

111
Views
0
Helpful
1
Replies
CreatePlease to create content