Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Configuring two T-1's on CME router 3845

We have 2 T-1's coming in from the Phone company. One for local calls and second one for Long distance calls. How can I configure these on CME router so when calls are placed to outside world, they are routed to the right T-1 ports?

Is there a sample config?

Thanks

AD

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Configuring two T-1's on CME router 3845

AD,

You can configure specific route patterns to force calls out each port.

dial-peer voice 1 pots

destination-pattern 9..........

port 0/0/0

description Local

dial-peer voice 2 pots

destination-pattern 91..........

port 0/0/1

description LD

You will have to create additional patterns for 9011! and 911/411, 9911, 9011! and 9....... for 7 digit dialing if required. (911 is a must)

PS: please remember to rate posts!

1 REPLY

Re: Configuring two T-1's on CME router 3845

AD,

You can configure specific route patterns to force calls out each port.

dial-peer voice 1 pots

destination-pattern 9..........

port 0/0/0

description Local

dial-peer voice 2 pots

destination-pattern 91..........

port 0/0/1

description LD

You will have to create additional patterns for 9011! and 911/411, 9911, 9011! and 9....... for 7 digit dialing if required. (911 is a must)

PS: please remember to rate posts!

126
Views
0
Helpful
1
Replies
CreatePlease to create content