Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

connect CCME to Nortel meridian

Hi I currently have a CCME connected to my Option81 Meridian system VIA E&M, they are not that reliable so i would like to connect using E1. Has anyone done this? I have a 1760 router running CCME and I am not sure on the hardware that I would need at either end and what the best protocol would be, I am assuming Q931.

regards

colin

2 REPLIES
Blue

Re: connect CCME to Nortel meridian

you can use a VWIC-2MFT-E1 card or the likes. you can put this into your 1760 if you have the slot available. if not, another router will be required. (requires ISO 12.2(4)YB +)

see the following link for 1700 VWIC support:

http://www.cisco.com/en/US/products/hw/routers/ps221/prod_bulletin09186a00800920eb.html

you can use E1-CAS R2, CCS signaling/Qsig (q931).

create this as a tie trunk from your Meridian.

see the following link for more PBX trunking support config info: (also a link for overall CME config guides)

http://www.cisco.com/en/US/products/sw/voicesw/ps4625/products_configuration_guide_chapter09186a00806a803b.html

http://www.cisco.com/en/US/products/sw/voicesw/ps4625/products_installation_and_configuration_guides_list.html

you may also want to look into cisco PTC (packet telephony center) for some solution guidance; this is more for the ISP side so you may not want/need.

New Member

Re: connect CCME to Nortel meridian

great reply

thanks

colin

128
Views
10
Helpful
2
Replies
CreatePlease login to create content