Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Connecting 2 ATAs through 2 routers in different IP networks

Hello,

I want to connect 2 ATA186 through a pair of routers. Both ATAs have different static IP network address, and this networks are connected through the routers, so I want to know which parameters I have to configure. I suppose that Static IP address /Subnet mask, Gateway = the local router Ethernet IP address and StaticRoute = the network IP address, and also H.323 in both ATAs. Is this correct ? I have to configure anything else ?

Thanks a lot for your help !

Regards, Anacelia

1 REPLY
New Member

Re: Connecting 2 ATAs through 2 routers in different IP networks

You can use the following URL for getting help in configurind ATA186. These documents gives you the configurations required.

http://www.cisco.com/warp/public/788/voip/ata_basicconfig.html

http://www.cisco.com/warp/public/788/voip/ata_gatekeeper.html

110
Views
0
Helpful
1
Replies