I have to connect a Norstar to a 3660 router via BRI. Both devices sit in the same data center. Then I want to add that 3660 as a gatway to my CCM cluster 500miles south so I can 5 digit dial from office to office. The CCM piece is the easy part. We have an established IPSEC tunnel between sites.
I can not seem to be able to fine any documentation on this. Any help would be great.
PS Is there an easier way to do this. I know that I need dial-peers on the 3660 not sure about the Norstar.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...