Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Connecting a VIC2-4FXO via an RCA connector.

I have a customer that wants to connect a VIC-4FX0 WIC to a Peavey MMA875T amplifier (which is used for a warehouse intercom system) via an RCA connector. The cable would be connected from the (4-pin) WIC to the line-in on the amplifier through the RCA connector.

It is this RCA termination that, for me, poses an issue.

Is this technically possible, and if so, how would it be possible? The VIC-4FX0 WIC uses a 4-pin cable: which of the pins would be connected to the RCA connector?

As a note, I have never performed this sort of set-up, so please treat me as a newbie, in this regards.

Any assistance or answers would be highly appreciated!

2 REPLIES
Hall of Fame Super Gold

Re: Connecting a VIC2-4FXO via an RCA connector.

Hi, you have to verify that the amplifier input is to be connected to an FXO port. Beside that the physical connection is not of significance. Just use the the inner pins.

please rate post if it helps!

New Member

Re: Connecting a VIC2-4FXO via an RCA connector.

You can also look into purchasing a paging unit from valcom. http://www.valcom.com/v%2D9970.htm

Thanks,

Robert

193
Views
0
Helpful
2
Replies