Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Connecting CCM 3.3 to Tadicom Coral III

I have created a gateway based on a 2651 XM, using an E1 isdn 30 bundel, made the Coral qsig master and CCM qsig slave. Everything works except one thing

Calling name identification presentation as per ISO 13868 does any one have an idea if CCM meets this standard or there is an way CCM can be manipulated so that it can meet this standard.

1 REPLY
Silver

Re: Connecting CCM 3.3 to Tadicom Coral III

Cisco offers support for Q.SIG basic call and ID services for selected MGCP- controlled gateways and for selected PBX. ID services support depends upon the PBX type. In general, Cisco makes support services available for Calling Line Identification Presentation (CLIP), Calling Name Identification Presentation (CNIP), Connected Name Identification Presentation (CONP), and Calling/Connected Line Identification Restriction (CLIR) for basic calls. The system design guides provide details of compatible PBX software loads, configuration, and operational caveats. Currently supported gateways include WS-6608-T1, WS-6608-E1, Cisco Access Digital Trunk Gateway DT-24+, and Cisco Access Digital Trunk Gateway DE-30+.

You can check the following links for the standards supported by CCM and for the QSIG statndards

http://www.cisco.com/univercd/cc/td/doc/product/voice/c_callmg/3_3/rel_note/332cmrn.htm#1344646

http://www.qsig.ie/qsig/updates/

http://www.qsig.ie/faq.htm

186
Views
0
Helpful
1
Replies
CreatePlease to create content