Connecting CCM Cluster to Nortel IP-PBX using ICT

[csco10709758]

Anyone attempt to make this type of WAN connection? I assume it would need to be a non-Gatekeeper controlled ICT? Is it as simple as pointing the ICT to the IP address of the Nortel PBX?

Any tips or comments are greatly appreciated!

[csco10709758]

Anyone?

[rchilcote]

CCM Inter-cluster trunks are strictly used for connecting 2 or more CCM Clusters together. I'm assuming the Nortel is using H.323 as the call setup protocol. Configure an H.323 gateway in CCM and place the IP of the Nortel PBX in the Device Name field. Then configure your route group, route list(s), and route patterns to send calls to the PBX.