Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Connecting Fax machines using VG248 GW

We have 8 port Brook Trout board on our FAX server and 31 individual FAX lines that use DID's through the PBX. We are adding Cisco 3845 Router with CME 4.0 and will be replacing the PBX in a few months. How can we route the faxes through CME using DID's? We have a total of 39 fax lines (using DID's) Is VG248 supported by CME 4.0? if not is there any other solution?

Thanks

AD

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Connecting Fax machines using VG248 GW

Even though 248s use SCCP, i dont see them supported in the list of hw.

http://www.cisco.com/en/US/products/sw/voicesw/ps4625/prod_installation_guide09186a00805f5908.html

PS: please remember to rate posts!

2 REPLIES

Re: Connecting Fax machines using VG248 GW

Even though 248s use SCCP, i dont see them supported in the list of hw.

http://www.cisco.com/en/US/products/sw/voicesw/ps4625/prod_installation_guide09186a00805f5908.html

PS: please remember to rate posts!

New Member

Re: Connecting Fax machines using VG248 GW

122
Views
0
Helpful
2
Replies