Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Connecting to a DEC600e

Has anyone had the wonderful experience of connecting a Cisco router (a 2821 in this case) to a DEC600e carrier switch? I currently have 3 T1's (b8zs/esf wink) connected to an Avaya Definity G3si PBX. If I pull the T1's out of the Avaya and put them into my router, I can recieve calls, but not send them.

Does anyone have experience with this old DEC switch that can help?

Thanx,

-Tim

1 REPLY
Bronze

Re: Connecting to a DEC600e

you might want to check dial-peers config on 2821.

also might want to look into debugs. useful commands 'debug voip ccapi inout' and 'debug vpm signal'

112
Views
0
Helpful
1
Replies
CreatePlease to create content